?unique=619daef)
TIMCAL SUPER C65 Conductive Carbon Black Powder
The C-NERGY SUPER C65 is a high performance conductive carbon black powder made by IMERYS. SUPER C65 was introduced by IMERYS as an improved version of the <strong>SUPER P</strong> carbon black. SUPER C65 is an ultra-high purity product that has been used as a conductive additive in lithium ion battery electrodes (<strong>cathode</strong> and <strong>anode</strong>) to improve the battery performance.
TIMCAL SUPER C65 Conductive Carbon Black Powder
Advantages:
• The lowest Fe impurity level (1 ppm)
• High specific surface area (62 m2/g)
• Superior battery performance The Imerys C-NERGY SUPER C65 carbon black meets the highest purity requirements for low metallic impurities and grit. The primary purpose of use of these SUPER C65 carbon black is to provide electrical conductivity to lithium-ion battery electrodes at low to very low loading.
Application Benefits:
• The lowest Fe impurity level (1 ppm)
• High specific surface area (62 m2/g)
• Superior battery performance The Imerys C-NERGY SUPER C65 carbon black meets the highest purity requirements for low metallic impurities and grit. The primary purpose of use of these SUPER C65 carbon black is to provide electrical conductivity to lithium-ion battery electrodes at low to very low loading.
Application Benefits:
- Increased battery safety
- Lower rejection ratio
- Fully compatible with most electrolyte systems
- No additional pre-dispersing is needed
- No dispersing aid is needed
- Very high loading is possible
- Cost savings on NMP and faster drying time
- High energy density
- Improved power density
- Cost reduction thanks to lower dosage needed
- Improved flexibility of the electrode
Technical Properties:
| Volatile Content | 0.15 % max |
| Toluene Extract | 0.1% max |
| Ash content (600°C) | 0.025% max |
| Grit content > 45 microns / 325 mesh | <2 ppm |
| Grit content > 20 microns / 625 mesh | <10 ppm |
| BET specific surface area (SSA) | 62 m2/g |
| Primary Particle Size (based on TEM) | less than 50 nm |
| Adsorption stiffness value | 32 ml/5g |
| Moisture | 0.1% |
| Density | 1.60 g/cm3 |
| Sulfur Content | 0.02% |
| pH | 10 |
| Iron (Fe) | 1 ppm |
| Nickel (Ni) | <1 ppm |
| Cobalt (Co) | < 1 ppm |
| Vanadium (V) | < 1 ppm |
| Chromium (Cr) | < 1 ppm |
| Copper (Cu) | < 1 ppm |
| Package | Packaged in an air-tight container sealed in an aluminum vacuum bag |